The 'down' arrow key (or moving mouse or joystick up) fires the burner and when air is hot enough the balloon will take-off. With just two keys you can take to the skies and look down at the earth. Major Tom is probably the easiest and most relaxing way of flying in GeoFS. When roll/yaw mixing is disabled, use the rudder keys (default are keys ) for the anti-torque (yaw).įor an in-depth introduction to helicopter flight, please refer to this great series of article from Flying Major Tom: In GeoFS, the collective pitch is controlled using the same input as the throttle for airplanes: if you press '+' several times, the helicopter will lift-off, if you press '-' it will go down.Ĭyclic pitch can be controlled using the arrow keys or the mouse. Ideally, you would have to use a joystick to be accurate enough with the helicopter but the mouse should be enough for a start. This has to be disabled (in configuration panel) in order to properly fly the helicopter. The basic principle is to play with collective pitch (going up and down), cyclic pitch (going forward, backward, right and left) and anti-torque control (rotation/yaw).īy default, mouse and keyboard controls are mixing roll and yaw (aileron and rudder). Helicopters are by definition much more difficult to fly than airplanes. All other keyboard controls are the same.You can reconfigure every axis and buttons of the joystick from the "option" panel.Joystick axis and button are by set by default.All other keyboard controls (except for arrows) are the same.You can configure the mouse (sensitivity, exponential) from the "option" panel.left/right for roll (mixed with yaw by default but can be configured).push/pull for tilt (or use the reverse option in configuration panel).Press M again to re-enable mouse control. Press M to temporarily disable the mouse (while navigating menus and options).Tab: fly to camera location (in free camera mode).CTRL + W: toggle orbit camera vertically (in follow or cockpit mode).CTRL + Q: toggle orbit camera (in follow or cockpit mode).0 to 9: Directly set throttle by 10% steps.You can configure the keyboard sensitivity from the "option" panel.Z: Accessories toggle (floats, water rudders, tailhook).B: extend/retract air-brakes (when available).G: raise or lower the landing gear (when available).Home/End: increase/decrease elevator trim.F: Cycle flaps one step at a time (when available).]: raise the flaps one step (when available).[: lower the flaps one step (when available).Press - again when idling to engage reverse when available
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |